Poly-L-Ornithine Solution (0.01%), 1 X 100 mL (A-004-C)

Research Category: Stem Cell Research Research Sub Category: Adhesion (CAMs) Poly-L-Ornithine Solution (0.01%) has been used to coat:glass-bottom plates for cell plating in a research study investigating the localization of cMET in MDA-MB-468 cells using confocal microscopyculture dishes for adult human neural stem cells (ahNSCs) primary culture6-well plates for induced pluripotent stem cells (iPSCs) culture and neuronal differentiation Product is presented in sterile water at 0.01% w/v (0.1mg/ml). Product is filtered through a 0.2 micron filter before freezing. Unless otherwise stated in our catalog or other company documentation accompanying the product(s), our products are intended for research use only and are not to be used for any other purpose, which includes but is not limited to, unauthorized commercial uses, in vitro diagnostic uses, ex vivo or in vivo therapeutic uses or any type of consumption or application to humans or animals. 1. Thaw Poly-L-Ornithine solution at room temperature. 2. Dilute Poly-L-Ornithine solution to the desired concentration in sterile water. 3. Fully coat the cell culture surface with diluted Poly-L-Ornithine solution. Use 5 mL volume for 6-cm plates and 10 mL volume for 10-cm plates and T75 flasks. 4. Allow the cell culture vessel to sit at room temperature overnight. 5. Aspirate the Poly-L-Ornithine solution the following day and rinse the vessel with sterile water followed by coating with desired ECM protein. Optimal coating concentrations must be determined by the end user. Typical coating concentrations range from 10ug/ml to 100ug/ml based on cell type and application. Store at -20°C for up to 4 months from date of receipt. Avoid multiple freeze thaw cycles to maintain product integrity. Solution is clear with no particulates present. Solution is sterile and suitable for cell culture applications.

Read Less